onyx_ptp_interface – Configures PTP on interface

New in version 2.8.

Synopsis

• This module provides declarative management of PTP interfaces configuration on Mellanox ONYX network devices.

Parameters

Parameter	Choices/Defaults	Comments
announce_interval -		configure PTP announce setting for interval, Range -3-1
announce_timeout -		configure PTP announce setting for timeout, Range 2-10
delay_request -		configure PTP delay request interval, Range 0-5
name - / required		ethernet or vlan interface name that we want to configure PTP on it
state -	Choices: enabled ← disabled	Enable/Disable PTP on Interface
sync_interval -		configure PTP sync interval, Range -7--1

Notes

Note

• Tested on ONYX 3.6.8130
• PTP Protocol must be enabled on switch.
• Interface must not be a switch port interface.

Examples

- name: configure PTP interface
  onyx_ptp_interface:
    state: enabled
    name: Eth1/1
    delay_request: 0
    announce_interval: -2
    announce_timeout: 3

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key	Returned	Description
commands list	always	The list of configuration mode commands to send to the device. Sample: ['interface ethernet 1/16 ptp enable', 'interface ethernet 1/16 ptp delay-req interval 0', 'interface ethernet 1/16 ptp announce interval -1']

Status

• This module is not guaranteed to have a backwards compatible interface. [preview]
• This module is maintained by the Ansible Community. [community]

Authors

• Anas Badaha (@anasb)

Hint

If you notice any issues in this documentation, you can edit this document to improve it.